+1 (954) 946-9454

Drawdown Vacuum Plates

Article No. 11204

Drawdown Vacuum Plate, 9x12"

These high quality Drawdown Vacuum Plates are for use with wet film applicators and are machined from hard aluminum solid bar stock. They are black anodized which gives high durability along with corrosion resistance, this will increase wear and longevity of the vacuum plate. 

Select your model

$2,200.00 excl. taxes & shipping cost

Features

  • The top section of the plate has a series of holes. When attached by a hose connection to a vacuum pump or sink aspirator, the vacuum created will hold down paper draw down charts during application of wet coatings with any type of film applicator.
  • The DP-B2133 12x18 Aluminum vacuum plate has dual-zone capability.
  • The vacuum can be isolated to the 9x12 area or the full 12x18 area can be used under vacuum.
  • There are two ports on the side of the vacuum plate that select the two zones. If the 9x12 area is just required you would supply vacuum to one port, if the 12x18 area is desired you would use both. You have to apply vacuum to both ports to get the entire 12x18 area under vacuum.
  • Included are 2 brass barbed fittings and a nylon Y fitting.
  • Each plate comes complete with hose fitting and rubber footing.
  • An optional chrome plated brass ball valve is available, this valve has an easy on/off lever handle to enable or disable vacuum.
  • Note the DP-B2133 requires two valves to control two ports/zones.
Join our Email List. subscribe
CANCEL