+1 (954) 946-9454

Formed Film Applicator Rods

Article No. 10365

Formed Rod, 4.0 mils, 10mm dia.

  • Formed Rod
  • 4.0 mils
  • 10 mm diameter

More options

Rod Length & Diameter
Approximate Wet Film Thickness
$81.00 excl. taxes & shipping cost

Features

  • No wires to break
  • Easier Cleanup
  • Less Expensive
  • Uniform spacing
  • Little change to overall dia.
  • Formed - the grooves have a wide radius at the bottom (like a "U")
  • Wire Wound - the "valley" between windings comes to a point (like a "V")
  • Applications: Adhesives, Board, Cellulose, Ceramic Colors, Cosmetics, Driers, Duplicating Inks, Emulsions, Fillers, Floor Polishes, Lacquers, Metallic Powders, Oils, Paper, Photographic Papers, Pigments, Plastics, Printing Inks, Resins, Varnishes, Waxes and Hotmelts
  • Click here to see the Wet Film Thickness Conversion Chart

Technical Attributes

  • Rod Length & Diameter
    16" x 10mm
  • Approximate Wet Film Thickness
    4.0 mils / 101.6 µm
  • Data
    Core:303 Stainless Steel
    Wire:302 Stainless Steel
    Core Diameter:+0 to -0.5 mils
    Wire Diameter:+0 to -0.5 mils
    Core Straightness:0.006”/ 12”

Procedure

Drawdowns are an inexpensive method of making laboratory samples to determine coating thickness, substrate penetration, fluid compatibility, bond strength, etc. Drawdown rods enable the technician to perform these tests with a minimum of effort. The procedure is as follows:

  1. Attach (or tape) a sample of the most suitable substrate to the glass surface of the Drawdown Plate.
  2. Using a spatula, place a small pool of coating liquid near the top of the sample sheet.
  3. Immediately grasp the ends of the Drawdown Rod. Using the thumbs of both hands to keep the rod from bowing or bending away from the sample, draw the rod down through the liquid pool spreading and metering the fluid across the sample sheet. As the drawdown is made, note the behavior of the coating and any possible reaction with the substrate. (Note: It may be convenient to construct a small trough of cardboard to catch the excess liquid as it is drawn to the bottom edge of the drawdown board.) Immerse rod in Cleaning Tray after use.
  4. The coated sample is now ready for testing.
  5. If the coating application is too thin, use a rod with a larger diameter wire. Hence, if the coating is too thick, use a rod with a smaller diameter wire.

Other Variations

Join our Email List. subscribe
CANCEL