Cross Hatch Kit, single blade
Article No. 12614
Cross Hatch Handle, Alu
Aluminum Cross Hatch Handle
- Ergonomic aluminum handle
- For 1-edge blades
- Blade not included
Features
The crosshatch paint adhesion test kits also have the one edge blade option to comply with the appropriate ASTM and ISO coating adhesion test methods.
- Blades made from hardened steel alloy for long life
- Pivoting head blade holder for easy alignment onto the coating surface
- Test kit comes with all the accessories necessary to perform cross-hatch test
Technical Attributes
-
- Material
- Alu handle
-
- Standard/Cutter Spacing
- -
-
- Weight
- 0.16 kg
-
- Weight
- 0.35 lb
-
- Dimensions: L x W x H
- 15.2 x 2.5 x 2.5 cm
-
- Dimensions: L x W x H
- 5.75 x 1 x 1 in
Technical Properties
Technical Specifications
General
Standards
Procedure
- Prepare test specimen as outlined in ASTM D3359.
- Position the blade in the handle with the holes facing the securing set screws, take care not to over tighten.
- Place the cutter assembly on the test specimen so that the guide and cutter rests on the substrate.
- Grasp handle and rotate it upward with respect to the line of contact of the guide with the test surface. During this motion, the tips of the cutter first contact the test surface when the top of the handle is about seven degrees with respect to the test surface. Continue this motion until the top surface of the handle is elevated to about 15 degrees. This is the correct attitude of the cutter assembly for the test.
- Apply enough pressure on the handle to insure that all of the cutter tips penetrate the test specimen supporting base, pull assembly along the test surface through 0.75 to 1 inch. Repeat this procedure with a second cut intersecting the first pattern at 90° (±5°). Evaluate results of the test as indicated in ASTM D3359, method B.
Delivery Content
Blade Handle
Clamp Screws (2)
Hex Wrench (1)
Clamp Screws (2)
Hex Wrench (1)
Downloads
Short Instructions
Accessories
Other Variations